All wall and window wall installations must provide for proper drainage.
Ptac wall sleeve installation instructions.
Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note.
Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70.
Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
While the dimensions may appear to be incompatible the 2 devices should fit properly.
16 24 28 and 31 deep cases are available for thicker walls.
See the drain kit for internal actual installation instructions.
The wall sleeve be installed a minimum of 36 from the ceiling.
All wall and window wall installations must provide for proper drainage.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
Wall case must be sealed caulked to outside wall on all four 4 sides.
For new installs ensure the wall is properly framed to support the weight and dimensions of the wall sleeve and air conditioner.
Consult a licensed contractor as needed.
Tools required by.
The wall sleeve must be fastened securely before installing the air conditioner unit.
The sleeve will fit flush in the wall extending outside the structure.
Figure 4 minimum interior and exterior note.
Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories.
Prepare and install the new wall sleeve according to the instructions below.
When a drain kit is to be installed do so before top of wall sleeve installing the wall sleeve in the wall.
Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
Wall case should be sealed caulked to the inside wall on all four 4 sides.
There is a portion of the air conditioner which extends a few inches back into the room.
The air conditioner will slide into the sleeve but is not flush with the wall.
If the sleeve projects more than 8 into the room a sub base or other means of support must be used.
Failure to install and maintain our product according to these instructions may void any product warranty.
This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to.
Standard steel wall cases are 42 w 16 h 13 3 4 d.
